Rock-magnetic measurements along with grain size, acid-insoluble residue (AIR), organic carbon (OC), CaCO3 and δ18O of the planktonic foraminifers of the sediments were determined for 15 gravity cores recovered from the western continental margin of India. Magnetic susceptibility (MS) values in the surficial sediments reflect the land-derived input and, in general, are the highest in terrigenous sediment-dominated sections of the cores off Saurashtra–Ratnagiri, followed by the sediments off Indus–Gulf of Kachchh and then Mangalore–Cape Comorin.
The down-core variations in mineral magnetic parameters reveal that the glacial sediments off the Indus are characterized by low MS values/S-ratios associated with high AIR-content, low OC/CaCO3 contents and relatively high δ18O values, while those off SW India are characterized by low MS values/high S-ratio% associated with low AIR content, and relatively high OC, CaCO3 and δ18O values. Conversely, the Early Holocene sediments of all cores are characterized by high MS values/S-ratio% associated with high AIR content, low OC, CaCO3 contents and gradually decreased δ18O values. These results imply that during the Last Glacial Maximum (LGM), the cores off northwestern India received abundant continental supply leading to the predominance of eolian/fluvial sedimentation. In the SW region the influence of hinterland flux is less evident during this period, but convective mixing associated with the NE monsoon resulted in increased productivity. During the early Holocene intense SW monsoon conditions resulted in high precipitation on land, which in turn contributed increased AIR content/MS values in the continental margin sediments. A shallow water core off Kochi further suggests that the intense SW monsoon conditions prevailed until about 5 ka. The late Holocene organic-rich sediments of the SW margin of India were, however, subjected to early diagenesis at different intervals in the cores. Therefore, caution is needed when interpreting regional climatic change from down-core changes in sediment magnetic properties. 相似文献
In this study, organic carbon (OC), total nitrogen (TN), stable carbon isotopic (δ13COC) and CuO reaction product compositions were used to identify the sources of organic matter (OM) and to quantify the relative importance of allochthonous and autochthonous contributions to the western Adriatic Sea, Italy. Suspended particulate material (195 samples) and surficial sediments (0–1 cm, 70 samples) from shallow cross-shelf transects were collected in February and May 2003, respectively. Vertical water column profiles were acquired along the same transects. Data include depth, potential temperature, salinity, density and chlorophyll fluorimetry.Along the western Adriatic shelf in the near-shore region, the phytoplankton growth was influenced by dynamics of the buoyant plumes from the Po and Appennine rivers. A small amount of very fine terrigenous material remained suspended within the coastal current and was exported southward along the shelf to the slope. High variability in the bulk composition was detected in the Po prodelta surficial sediments, whereas the western Adriatic shelf, although a larger area, exhibited a narrower range of values.A significant decoupling was observed between suspended particles in the water column and surficial deposits. The organic material collected in the water column was compositionally heterogeneous, with contributions from marine phytoplankton, riverine–estuarine phytoplankton and soil-derived OM. Frequent physical reworking of surficial sediments likely leads to the efficient oxidation of marine OC, resulting in the observed accumulation and preservation of refractory soil-derived OC delivered by the Po and Appennine rivers. 相似文献
Scientific sea-floor dredging is currently used in marine geology primarily by the hard-rock community interested in the recovery of basement rock samples from the unsedimented deep ocean floor. The technique has generally been eclipsed by ocean drilling for recovery of sedimentary rocks, because of perceived uncertainties in the location of sampling and in the representativeness of recovered material. This contribution reviews dredging equipment currently in use by marine geological institutions and refers to pinger attachments that allow precise information on the behaviour of the dredge to be telemetered back to the ship. We argue that improvements in ship navigation and transponder navigation at the seafloor, when used in conjunction with surface and/or deeply towed sidescan and swathemapping surveys, now allow for considerably less uncertainty on the location of dredge sampling. Refined sorting criteria for dredge hauls are now also available. Recent comparisons of regional sample recovery by ocean drilling and by dredge sampling indicate that the dredge hauls can usefully supplement the drilling data in the construction of sedimentary and tectonic histories of seafloor areas. 相似文献
